This document describes the GSM half-rate voice coding implementation on the TMS320C62xx processor (also called the vocoder). It discusses the system requirements and gives two levels of detail for the subroutines. The first level is designed for programmers who want to use the code in a basic GSM architecture. The second level is for programmers who want to see how the code is implemented for mod

This software demonstration combines real-time D1 Joint Photographic Experts Group (JPEG) encoding and decoding of images on the DM642 Evaluation Module (EVM) with networking functionality.

The JPEG standard pertains to compression of still images. Performing JPEG compression at the rate of 30 frames per second in isolation as individual images is known as motion JPEG (MJPEG). This demonstrat

This application report describes two methods for implementing a digital sine-wave generator using the TMS320C2xx: the use of a direct look-up table with linear interpolation, and the use of mathemati

The ADS7843 is a 12-bit sampling analog-to-digital converter (ADC) used to drive 4-wire touch-screens to serial interfaces by ratiometrically converting two differential input signals. The ADS7843 also produces an accurate output with the first conversion cycle once powered up.

This application report analyzes a simple method for calculating minimum acquisition times for successive-approximation register analog-to-digital converters (SAR ADCs). The input structure of the ADC

Bipolar linear integrated circuits have been with us for years in the form of PWM and PFC controllers supervisory circuits and other circuits. Since these devices have traditionally used relatively high-voltage (35V) bipolar processes powering was not a concern. In addition many of these ICs contained high-current protection zeners to keep higher voltages from damaging the devices. With a numb

The Texas Instruments (TI)(tm) TMS320F240 digital signal processor (DSP) controller contains a hardware deadband unit that automatically generates a deadband in the six PWM (pulse width modulation) signals from the full compare unit. This document describes how the DSP can use the other six available PWM signals to drive a second three-phase inverter with deadband.

TMS320DM365,TPS74801,TPS74701 Simple Power Solution Using LDOs for the DM365

The THS8133, THS8134, THS8135, and the THS8200 devices are part of a family of chips for graphics and video applications, which contain triple DACs that operate from 80 MSPS to 240 MSPS. For televisio

TPS92641 Brightness Turbo TPS92641 Application Note

This application note discusses programming of the LM628/LM629 motion control processors.

This application report discusses the process of replacing the CLC001 cable driver with the LMH0001 cable driver.

Generating a high-frequency system clock Fs (128fs to 768fs) from a low-frequency sampling clock fs (10 kHz to 200 kHz) is challenging while attempting to maintain low phase jitter. A traditional phase-lock loop (PLL) can do the frequency translation but the added phase jitter prevents the generated system clock signal from effectively driving high-performance audio data converters. This applica

There is a lot of confusion about how to operate a fully differential op amp from a single power supply. This application note describes how to select the correct dc operating point of a fully differential op amp.

This application report has supplemental information about using the DM646x video port. The tips and tricks in this document are useful in video security applications as well as other applications that make use of the video port.

The current generation of Texas Instruments (TI) TMS320C6x (C6x) digital signal processors (DSPs) is 100X more powerful than DSPs available 15 years ago. As DSP capability has increased product designers have created more complex software applications. Three years ago a typical wireless application had 6000 (100 Kbytes) lines of C code - today the typical application has 31000 (500Kbytes) lines

This document explains the recommended configuration to operate the TFP101/201/401(A) devices in the 2Pixel/Clk mode.

Easy-to-use Cabling Interface for Measuring Temperature with the TMP107 TMP107

TPS63* Design Calculations for Buck-Boost Converters LEAVE IN MS WORD

This application report provides a summary of the main changes required for porting an application written on the Hercules™ TMS570LS20x/10x series of microcontrollers over to the Hercules TMS570LS31x/21x series of microcontrollers. A brief description of the process technology differences is also included.