AN-1442 Design and Programming Examples for Lighting Management Unit LP 5526

The TPS75005 is a complete power management solution for the C2000™ controllers from Texas Instruments. This document is supplemental advanced information to the TPS75005 data sheet.In this advanced information document the integrated sequencer logic (state machine) is explained in detail.

This application report provides a methodology for calculating the useful lifetime of TI embedded processors (EP) under power when used in electronic systems. It is aimed at general engineers who wish

AN-664 ISDN Basic Rate Interface Terminal Equipment (TE) System Design Guide

This report shows how to interface TLV2541 and TLV5636 12-bit serial data converters to the TMS320C5402<TM> DSP via the McBSP. It presents a hardware solution and a software solution to interface the

The strong interest in this application report leads us to publish a second edition. In addition to changes and updates made throughout all sections, new parts have been added, such as M?LVDS, CAN, Cl

SLIO-CAN CAN-Linked I/O Based on COP884BC

The interfacing of the 3-V MSP430x1xx and MSP430x4xx microcontroller families to circuits with a supply of 5 V or higher is shown. Input, output and I/O interfaces are given and explained. Worse-case

Boost converters are susceptible to large inrush currents at startup and with step changes in VLINE because the output capacitor is connected directly to the input through the boost diode. This design note describes and provides a schematic for a circuit that provides overcurrent shutdown using the UC3853 High Power-Factor Preregulator. The UC3853 provides simple yet high-performance active power

This application report presents a hardware and software solution for interfacing the TLV2544/TLV2548 12-bit, 200-ksps, 4/8-channel, low-power, serial, successive approximation register (SAR) analog-to-digital converters (ADCs) to the 32-bit floating point TMS320C3X digital signal processor (DSP) through the use of the TMS320C31 DSP starter kit (DSK).

A digital-to-analog converter (DAC) interface to the DSP is also presented here exclusively for the single-shot mode operation of the ADC, since the DAC is used to reconstruct the digital data from the ADC for verification purposes. The TLV5618A DAC is used for this report.

ALM2402Q1 ALM2402Q1 Applications Note

This application report assists in estimating the power consumption for the TMS320C5515, C5504, C5505, C5514, C5532, C5533, C5534, and C5535 devices (DSPs), using a power estimation spreadsheet.

Texas Instruments has developed a family of peak current mode hysteretic buck regulator controllers(such as the LM27212 the LM27213 and the LM27292 and so forth). This architecture has somecharacteristics that differ from its PWM counterpart. This application report highlights some of theseunique characteristics and discusses the tradeoffs involved.

This application report provides a step-to-step initialization guide for the Keystone II device DDR3 SDRAM controller.

This application report describes two methods to obtain a gain setting for a fixed-gain audio power amplifier. Included is a detailed operation analysis.

Advanced Debugging Using the Enhanced Emulation Module (EEM) With IAR Embedded Workbench 5.60 /ASPD/MSP430/App_Reports/SLAA263