This application note presents a method for interfacing the modular MSOP8 evaluation module (EVM), an EVM for single-channel, low-power, 8- to 16-bit serial analog-to-digital converters, to the TMS320

This application report describes how to communicate with the Hercules™ UART bootloader. The UART bootloader is a small piece of code that can be programmed at the beginning of Flash to act as an application loader as well as an update mechanism for applications running on a Hercules Cortex™-R4 based TMS570LS04x microcontroller.

An efficient method of detecting combustion engine knock is using spectral analysis. The detection process algorithm adapts to a no-knock reference at varying speeds and loads by using multiple frequencies. This document presents an problem overview current technology and two implementation examples are given to aid in the development of system specific hardware and software. The first system is

This document describes the changes being made to the previously released bq20z90 (v102) design.

A combo is a codec (COder/DECoder) combined with a voice-band filter on a single chip. It converts analog voice-band signals into pulse code modulated (PCM) data and interfaces to 4-wire analog telephone circuits. This document targets the TCM29Cxx TP30xx and the TCM37Cxx combo family. It describes the chip development details device operation and provides application information on the combo

FDC1004 Capacitive Sensing: Out-of-Phase Liquid Level Technique

TPS53319 DCAP Mode with Ripple Injection Modeling Design Consideration China orignal written by Chinese engineer

LB-44 Get More Power Out of Dual or Quad Op-Amps

This application report explains an IMA Adaptive Differential Pulse Code Modulation (ADPCM) compression/decompression algorithm and the steps to use the ADPCM library on the MSP430. The usage of the A

This design note describes the key elements and simple usage of the industry standard <b>I²S</b> peripheral. The main objective is to explain the <b>CC111xFx/CC251xFx</b> software configura

The OMAP5910 processor contains an integrated LCD controller. Using internal memory and dedicated DMA channels this architecture contains a very efficient LCD control interface. This application note describes how to connect two different LCD displays to the OMAP5910. While there are many sizes and types of LCD displays in the industry this application note focuses on two 240 x 320 color thin fi

Sensorless Field Oriented Control of 3-Phase Permanent Magnet Synchronous Motors (DRV8312-EVM)

Integrated TFT- LCD Timing Controllers With RSDS Column Driver interface

AN-72 The LM3900: A New Current-Differencing Quad of Plus or Minus Input Amplifiers

This application report describes the TSM320DM6467 embedded Host electrical compliance of a high-speed (HS) universal serial bus (USB) operation conforming to the USB 2.0 specification. The non-OTG controller supports the USB 2.0 Host mode operation at HS full-speed (FS) and low-speed (LS) . Furthermore it supports the USB 2.0 device mode operation at HS and FS. LS operation when assuming the

Linear voltage regulators have long been an important resource to power supply designers. Three-terminal fixed-voltage linear regulators find extensive use as spot regulators and as post-regulation stages fed by switched-mode supplies. However while inexpensive and simple to use these devices have several performance limitations. They are inefficient power converters they lack versatility an

This application report describes the Flash and RAM ECC handling methods for TMSx70-based microcontrollers in general.

To use the Flash/RAM ECC the single error correction and double error detection (SECDED) module in the TMSx70 has to be configured accordingly. This application report covers typical software configurations of the SECDED modules and briefly explains some essential basics.