This document provides characterization information about low-voltage logic (LVL) that operates from a 3.3-V power supply. It addresses the issues of interfacing to 5-V logic ac performance power considerations input and output characteristics and signal integrity for this family of devices.

Using I2C Communication With the bq275xx Series of Fuel Gauges

This application report presents a hardware solution for interfacing the TLV1571/TLV1578 10-bit 1.25 MSPS low-power analog-to-digital converter (ADC) to the 16-bit fixed-point TMS320C542 digital signal processor (DSP). The report describes the interface hardware and C-callable software routines which support communication between ADC and DSP.

Efficient utilization of available memory in a TMS320C54x DSP sometimes requires the placement of data in program space memory (as opposed to data space memory). However accessing this data using the C programming language is problematic since the C-compiler provides no mechanism for accessing program space. This application note presents a solution for accessing data stored in program space mem

Once the main printed circuit board (PCB) has been designed, the assembly guidelines for the 0.5mm package-on-package (PoP) applications processor and companion memory device must be considered. PoP a

The LDC1000 is a programmable inductance-to-digital converter for use in inductance-sensingapplications. It offers a complete signal path solution between an LC tank and a microcontroller byproviding proximity and inductance data. The MSP430 is an ideal microcontroller solution for low-costlow-power precision sensor applications because it consumes very little power. This library provides

Proper installation is required to use the TI TSC2301 WinCE generic drivers with a given host processor. This includes copying the drivers into the corresponding directories and tailoring the processor-dependent layer (PDL) files for the drivers to the hardware specifications of the processor. This application report presents an example driver installation on an Intel? XScale? PXA250 Lubbock platf

Plastic Ball Grid Array [PBGA] Application Note

Test results from the PSE interoperability test performed on the TPS23861.

This document describes how to run a program in RAM load another application to the RAM base address and map the whole RAM to address zero without using a software interrupt in the boot memory block. The mapping is necessary for example if the RAM application needs to use specific interrupts. The interrupt vector table for the RAM application has then to be mapped to address zero.

The C674x Floating-point Processor generation combines a new level of performance / precision and dynamic range with high power efficiency and system integration. The C674x processors are completely code compatible with other C67x processors.

Application Note 337 Reducing Noise on Microcomputer Buses

TPS659037 Design Checklist Excel (for sorting and filtering information)

AN-414 Precautions for Disk Data Separator (PLL) Designs - How to Avoid Typical Probl ems.

Hermetic Dimensional/Thermal Data

This design was created to help those wanting to design a TMS320C6472 digital signal processor into a system using a nominal input of 12 V, having a highly flexible power design, and the ability to mo

AN-1153 COP8 Flash ISP HANDBOOK – Virtual E2 Guide

This application report provides points to be considered when upgrading an existing 10/100 Mb/s Ethernetdesign using Intel’s LXT971 or LXT972A Ethernet Physical Layer (PHY) product to the new TexasInstruments DP83848C/I/YB PHYTER™ product.