Dynamically selecting the desired bus configuration and format is useful for systems such as network switches and routers that use 32-to 36-bits of data or 8- and 16-bit controllers and buses. The SN74ABT3613 FIFO provides a unidirectional data path with bus-matching and byte-swapping on Port B while the SN74ABT3614 FIFO provides a bi-directional data path with bus-matching and byte-swapping in e

This application report provides several recommended power management solutions for the Intel™ StrataFlash™ Embedded Memory (P30). Intel has migrated from its third-generation 180-nm J3 process to its fourth-generation 130-nm P30 process on flash memory and will be discontinuing the older J3 256-Mb memory. Migrating from J3 memory to the P30 Embedded Memory allows systems to operate at

TPS65070, TPS65072, TPS65073, TPS650702, TPS650731, TPS650732 How to Power the TPS6507x On and Off

DN612 -- Design Notes

Noise reduction by filtering is the most commonly used method for improving signal-to-noise ratio. The increase in settling time however can be a serious disadvantage in some applications such as high-speed data acquisition systems. The nonlinear filter described here is a simple way to get a four-to-one improvement in settling time as compared to a conventional filter.

This application report presents a method for interfacing the DAC8806 and DAC8820 - single-channel, current-output, 14-/16-bit multiplying digital-to-analog converters - to the TMS320 series of digita

Application Note 295 A High Performance Industrial Weighing System

This report describes interface circuits for the TMS32010 to asynchronous inputs and to external memory devices such as external ROM or RAM. A description of hardware peripheral devices interface device produced by Pacific Microcircuits is also included which eases the TMS32010 interface to both external memory and codec devices.

TVP5146 PCB Layout Guidelines

In the header of most datasheet specification tables there is a qualifier for the tests defined in the table(TA = TJ unless otherwise stated). Specifically these tests are valid for the device as long as the junctiontemperature remains within the specified limits for that device.

CC1101 CC1110 CC2500 CC2510 CC430 Implementing 'Diversity' Using Low Power Radios

This document describes the change made from bq27505-J1 to bq27505-J2. The latest ordering information and data sheet are available on the TI Web site. Note that bq27505-J1 uses firmware version 2.07 and the bq27505-J2 uses firmware version 2.15.

This application report deals chiefly with the practical aspects of using the LM1894 but the informationgiven can also be applied to the LM832.

AB-004 Make a Precision -10 V Reference

Audio Amplifier Drives Thermoelectric Cooler For OC-48 Laser Module

JPEG an acronym for Joint Photographic Experts Group is an ISO/CCITT-backed international standards group that defined an image-compression specification (also referred to as JPEG) for still images. The following are mandatory in JPEG specification: algorithms must operate at or near the state of the art in image-compression rates; algorithms must allow for software only implementations on a wid

Motion detection using pyroelectric passive infrared (PIR) sensor elements is a common method used for such applications. An implementation of such a system using the 16-bit Sigma-Delta ADC integrated into the MSP430F2013 to detect motion is presented in this application report.

The formalization of the IEEE 1149.1 boundary-scan standard provides and infrastructure that aids test engineers and assists design engineers in the debug of hardware and software. This document provides and overview of the test standardization process and discusses a scan-based debug and integration compliant with IEEE 1149.1. The test its results and the limitations of the standard are discusse

DSP/BIOS Hardware and Software UART Device Drivers Application Report

TPS54120 Understanding Compensation Network for the TPS54120