4- and 8-Channel, 3V Micropower Sampling 12-Bit Serial I/O A/D Converters Features: 12-Bit Resolution on 3V Supply Low Supply Current: 160µA Typ Auto Shutdown to 1nA Guaranteed ±3/4LSB Max DNL Guaranteed 2.7V Operation (5V Versions Available: LTC1594/LTC1598) Multiplexer: 4-Channel MUX (LTC1594L) 8-Channel MUX (LTC1598L) Separate MUX Output and ADC Input Pins MUX and ADC May Be Controlled Separately Sampling Rate: 10.5ksps I/O Compatible with QSPI, SPI and MICROWIRE™, etc. Small Package: 16-Pin Narrow SO (LTC1594L) 24-Pin SSOP (LTC1598L)

Dual and Quad 250A, 3MHz, 200V/s Operational Amplifier Features: 3MHz Gain Bandwidth 200V/µs Slew Rate 250µA Supply Current per Amplifier C-Load™ Op Amp Drives All Capacitive Loads Unity-Gain Stable Maximum Input Offset Voltage: 600µV Maximum Input Bias Current: 50nA Maximum Input Offset Current: 15nA Minimum DC Gain, RL = 2k: 30V/mV Input Noise Voltage: 14nV/√Hz Settling Time to 0.1%, 10V Step: 700ns Settling Time to 0.01%, 10V Step: 1.25µs Minimum Output Swing into 1k: ±13V Minimum Output Swing into 500: ±3.4V Specified at ±2.5V, ±5V and ±15V Available in SO-8 Package LT1353 in Narrow Surface Mount Package

Digital to Analog Converters - DAC Quad, 16-Bit, +/-10V VOUT SoftSpan DACs with 10ppm/ C Max Reference

Very Low Noise, Differential Amplifier and 5MHz Lowpass Filter Features: Programmable Differential Gain via Two External Resistors Adjustable Output Common Mode Voltage Operates and Specified with 3V, 5V, ±5V Supplies 0.5dB Ripple 4th Order Lowpass Filter with 5MHz Cutoff 82dB S/N with 3V Supply and 2VP-P Output Low Distortion, 2VP-P, 800Ω Load 1MHz: 93dBc 2nd, 96dBc 3rd Fully Differential Inputs and Outputs Compatible with Popular Differential Amplifier Pinouts Available in an SO-8 Package

6.5 V, 2 A, Ultralow Noise, High PSRR, Fast Transient Response CMOS LDO Features: Download ADM7172-KGD Data Sheet. Available as Known Good Die and fully guaranteed to data sheet specifications. Input voltage range: 2.3 V to 6.5 V Maximum load current: 2 A Low noise: 5 µV rms independent of output voltage at 100 Hz to 100 kHz Fast transient response: 1.5 μs for 1 mA to 1.5 A load step 60 dB PSRR at 100 kHz Low dropout voltage: 172 mV at 2 A load, VOUT = 3 V Initial accuracy: −0.5% (minimum), +1% (maximum) Accuracy over line, load, and temperature: ±1.5% Quiescent current, IGND = 0.7 mA with no load Low shutdown current: 0.25 μA at VIN = 5 V Stable with small 4.7 µF ceramic output capacitor Adjustable and fixed output voltage options: 1.2 V to 5.0 V Adjustable output from 1.2 V to VIN − VDO Precision enable Adjustable soft start 8-lead 3 mm × 3 mm LFCSP package Supported by ADIsimPower™ tool

Dual, 16-Bit, 2Msps Differential Input ADC with Wide Input Common Mode Range Features: 2Msps Throughput Rate ±4LSB INL (Typ) Guaranteed 16-Bit, No Missing Codes 8VP-P Differential Inputs with Wide Input Common Mode Range 81dB SNR (Typ) at fIN = 500kHz –90dB THD (Typ) at fIN = 500kHz No Cycle Latency Guaranteed Operation to 125°C Single 3.3V or 5V Supply Low Drift (20ppm/°C Max) 2.048V or 4.096V Internal Reference 1.8V to 2.5V I/O Voltages CMOS or LVDS SPI-Compatible Serial I/O Power Dissipation 31mW/Ch (Typ) Small 28-Lead (4mm × 5mm) QFN Package

6.5 V, 500 mA, Ultralow Noise, High PSRR, Fast Transient Response CMOS LDO Features: Input voltage range: 2.3 V to 6.5 V Maximum load current: 500 mA Low noise: 5 μV rms independent of output voltage at 100 Hz to 100 kHz Fast transient response: 1.5 μs for 1 mA to 500 mA load step 60 dB PSRR at 100 kHz Low dropout voltage: 42 mV at 500 mA load, VOUT = 3 V Initial accuracy: ±0.75% Accuracy over line, load, and temperature: ±1.25% Quiescent current, IGND = 0.7 mA at no load Low shutdown current: 0.25 μA at VIN = 5 V Stable with small 4.7 μF ceramic output capacitor Adjustable and fixed output voltage options: 1.2 V to 5.0 V Adjustable output from 1.2 V to VIN − VDO Precision enable Adjustable soft start 8-lead, 3 mm × 3 mm LFCSP package Supported by ADIsimPower tool

Digital Controller for Isolated Power Supply Applications Features: Integrates all typical PWM controller functions 7 PWM control signals Digital control loop Integrated programmable loop filters Programmable voltage line feedforward Dedicated soft start filter Remote and local voltage sense Primary and secondary side current sense Synchronous rectifier control Current sharing OrFET control I2C interface Extensive fault detection and protection Extensive programming and telemetry Fast digital calibration User accessible EEPROM Qualified for automotive applications Download ADP1046AW Automotive Data Sheet (pdf)

1 A, Low Dropout, CMOS Linear Regulator Features: Maximum output current: 1 A Input voltage range: 2.5 V to 5.5 V Low shutdown current: <1 μA Low dropout voltage: 345 mV @ 1 A load Initial accuracy: ±1% Accuracy over line, load, and temperature: ±2.5% 16 fixed output voltage options with soft start: 0.75 V to 3.3 V (ADP1706) 16 fixed output voltage options with tracking 0.75 V to 3.3 V (ADP1707) Adjustable output voltage option: 0.8 V to 5.0 V (ADP1708) Stable with small 4.7 μF ceramic output capacitor Excellent load/line transient response Current limit and thermal overload protection

Broadband Modem Mixed-Signal Front End Features: Low cost, 3.3 V CMOS MxFE® for broadband modems 10-bit digital-to-analog converter (DAC) 2×/4× interpolation filter 250 MSPS DAC update rate 10-bit, 75 MSPS ADC Low noise RxPGA Dual channel muxed input 6 dB input overload attenuator −12 dB to +48 dB (without attenuator) Third-order programmable low-pass filter Flexible digital datapath interface Half-duplex and full-duplex operation Programmable delay Tx driver disable signal Various power-down/reduction modes Internal clock multiplier (PLL) 2 auxiliary programmable clock outputs 64-lead LFCSP

Ultrafast 3.3 V Single-Supply Comparator w/Reduced Swing PECL (RSPECL) Output Drivers Features: 3.3 V/5.2 V single-supply operation 150 ps propagation delay 15 ps overdrive and slew rate dispersion 8 GHz equivalent input rise time bandwidth 80 ps minimum pulse width 35 ps typical output rise/fall 10 ps deterministic jitter (DJ) 200 fs random jitter (RJ) On-chip terminations at both input pins Robust inputs with no output phase reversal Resistor-programmable hysteresis Differential latch control Extended industrial −40°C to +125°C temperature range

3-V, RS-232 Serial Port Driver-Receiver Features: Green Idle power-saving mode Single 2.7 V to 3.6 V power supply Operates with 3 V logic 0.1 µF to 1 µF charge pump capacitors Low EMI Low power shutdown: 20 nA Full RS-232 compliance 460 kb/s data rate One receiver active in shutdown (ADM3307E/ADM3311E/ADM3312E/ADM3315E) Two receivers active in shutdown (ADM3310E) ESD >15 kV IEC 1000-4-2 on RS-232 I/Os ESD >15 kV IEC 1000-4-2 on CMOS and RS-232 I/Os (ADM3307E) Qualified for automotive applications

High Voltage Current Shunt Monitor Features: Adjustable gain High common-mode voltage range 7 V to 65 V typical 7 V to >500 V with external pass transistor Current output Integrated 5 V series regulator 8-lead MSOP package Operating temperature range of −40°C to +125°C

Low Power, High Output Current, Quad Op Amp, Dual-Channel ADSL/ADSL2+ Line Driver Features: Four current feedback, high current amplifiers Ideal for use as ADSL/ADSL2+ dual-channel central office (CO) line drivers Low power operation Power supply operation from ±5 V (+10 V) up to ±12 V (+24 V) Less than 3 mA/amp quiescent supply current for full power ADSL/ADSL2+ CO applications (20.4 dBm line power, 5.5 CF) Three active power modes plus shutdown High output voltage and current drive 500 mA peak output drive current 42.6 V p-p differential output voltage Low distortion −93 dBc at1 MHz second harmonic −103 dBc at 1 MHz third harmonic High speed: 515 V/μs differential slew rate Additional functionality of AD8392AACP On-chip, common-mode voltage generation

High Speed, 4-Channel, 8-Bit CMOS ADC Features: 4 or 8 Analog Input Channels Built-In Track-and-Hold Function 10 kHz Signal Handling on Each Channel Fast Microprocessor Interface Single 5 V Supply Low Power: 50 mW Fast Conversion Rate: 2.5 µs/Channel Tight Error Specification: 1/2 LSB

3.0 V to 5.5 V, 12 kV IEC ESD Protected, Half Duplex 500 kbps RS-485 Transceiver Features: TIA/EIA RS-485 compliant over full supply range 3.0 V to 5.5 V operating voltage range on VCC 1.62 V to 5.5 V VIO logic supply option available ESD protection on the bus pins IEC 61000-4-2 ±12 kV contact discharge IEC 61000-4-2 ≥ ±12 kV air discharge HBM: ≥ ±30 kV Full hot swap support (glitch free power-up/power-down) High speed 50 Mbps data rate (ADM3065E/ADM3066E/ADM3067E/ADM3068E) Low speed 500 kbps data rate for long cables (ADM3061E/ADM3062E/ADM3063E) Full receiver short-circuit, open circuit, and bus idle fail-safe Extended temperature range up to 125°C PROFIBUS compliant at VCC ≥ 4.5 V Half duplex and full duplex models available Allows connection of up to 128 transceivers onto the bus Space-saving package options 10-lead, 3 mm × 3 mm LFCSP 8-lead and 10-lead, 3 mm × 3 mm MSOP 8-lead and 14-lead, narrow body SOIC

High Current Output, Triple Video Amplifier Features: Drives 13 V Output Drives Unlimited Capacitive Load High Current Output Drive: 70 mA Excellent Video Specifications (RL = 150 Ω) Gain Flatness 0.1 dB to 10 MHz 0.06% Differential Gain Error 0.02° Differential Phase Error Power Operates on ±2.5 V to ±7.5 V Supply 10.0 mA/Amplifier Max Power Supply Current High Speed 250 MHz Unity Gain Bandwidth (3 dB) 1200 V/µs Slew Rate Fast Settling Time of 35 ns (0.1%) High Speed Disable Function Turn-Off Time 30 ns Easy to Use 200 mA Short Circuit Current Output Swing to 1 V of Rails

8-Bit Analog-to-Digital Converter Features: 8-Bit Resolution No Missed Codes over Full Temperature Range Fast Conversion Time: 15 µs Interfaces to µP like RAM, ROM of Slow - Memory Low Power Dissipation: 30 mW Ratiometric Capability Single +5V Supply Low Cost Internal Comparator and Clock Oscillator

CMOS, 24-Bit Sigma-Delta, Signal Conditioning ADC with Matched RTD Excitation Currents Features: Charge-Balancing ADC 24 Bits, No Missing Codes ±0.0015% Nonlinearity 2-Channel Programmable Gain Front End Gains from 1 to 128 1 Differential Input 1 Single-Ended Input Low-Pass Filter with Programmable Filter Cutoffs Ability to Read/Write Calibration Coefficients RTD Excitation Current Sources Bidirectional Microcontroller Serial Interface Internal/External Reference Option Single- or Dual-Supply Operation Low Power (25 mW typ) with Power-Down Mode (7 mW typ)

Analog to Digital Converters - ADC 12-Bit 3Msps Sampling ADC