AN-453 COPS Based Automobile Instrument Cluster

This guide describes the main System-on-Chip (SoC) level and peripheral changes that need to be considered when migrating a KeyStone I-based system design to a KeyStone II-based system design. <p> I

Texas Instruments has a WIMAX RF chipset for base station and CPE applications that include integrated synthesizers to realize the superheterodyne architecture. For optimum channel resolution these devices must be tied to an 18-MHz reference frequency. In some systems the synthesizer reference frequency needs to be synchronized to a system reference frequency that may not be an integral multiple

This application note describes the Texas Instruments CDCR83 and CDCFR83 clocks for Direct Rambus system design. The document provides general guidance on power supply system board layout to achieve a high level of signal integrity and low clock jitter and translating switching level for various applications. This guide is not totally exclusive to the Rambus application and some of the

DN613 -- CC-Antenna-DK Nearson Kit Antenna OTA Test Results (868 MHz & 915 MHz) with EB

Signal Integrity Evaluation of Bourns Lightning Protection Solutions with High-Speed Interfaces

This application report describes a battery-less operation of a temperature and humidity sensor application. The implementation is done using the SHT21 relative humidity and temperature (RH&T) sensor from Sensirion (http://www.sensirion.com) an MSP430F2274 microcontroller and the TMS37157 (PaLFI) low-frequency device from TI. The complete power for operating the wireless sensor and the MSP430F22

SN74LVCXT245, SN74LVCHXT245 Designing with SN74LVCXT245 and SN74LVCHXT245 Family of Direction Controlled Voltage Trans

INITIALIZATION & ASYNCHRONOUS PROGRAMMING OF THE PCILYNX TSB12LV21A 1394 DEVICE USERS GUIDE

Application Note 1311 MPL PHY Layer Overview

VMEbus(TM) one of the most widely used backplanes in the industry has generated numerous end products by using third-party boards mechanical hardware software and backplane driver chips. The VME double-edged source-synchronous transfer (2eSST) protocol needs an I/O driver to transmit signals along the VMEbus at significantly higher speeds than those achievable with the VME64 standard. TI addr

This application note presents a method for interfacing the ADS8320/ADS8325 16-bit 100 KSPS SAR analog-to-digital converter to the TMS320C6711 DSP. Software developed for use in this application reads continuously from the converter. Explained within is how to use the BIOS/CSL and the configuration tool in Code Composer Studio? to set the McBSP and hardware interrupt vectors. The software can also

This application report assists in estimating the power consumption using the power estimation spreadsheet for the TMS320C5517 devices (DSP).

DS25CP104 in 3G SDI Router Application

Intel Core i3, i5, i7 Reference Design Application Report

bq500210, bq500410 and bq500211 bqTESLA Transmitter Coil Vendors LEAVE IN WORD

This application report shows how to use the Advanced Encryption Standard (AES) capability of the SimpleLink CC1200 low-power high performance transceiver. It shows how to do stand-alone CBS block operations and how to do in-line CTR mode security operations on TX/RX FIFO content. The application report assumes that the reader is familiar with the basic concepts of AES and the different commonly u

AMC1100: Replacement of Input Main Sensing Transformer in Inverters with Isolate AMC1100 Word File