This application report provides a methodology for calculating the useful lifetime of TI embedded processors (EP) under power when used in electronic systems. It is aimed at general engineers who wish

AN-664 ISDN Basic Rate Interface Terminal Equipment (TE) System Design Guide

This report shows how to interface TLV2541 and TLV5636 12-bit serial data converters to the TMS320C5402<TM> DSP via the McBSP. It presents a hardware solution and a software solution to interface the

The strong interest in this application report leads us to publish a second edition. In addition to changes and updates made throughout all sections, new parts have been added, such as M?LVDS, CAN, Cl

SLIO-CAN CAN-Linked I/O Based on COP884BC

The interfacing of the 3-V MSP430x1xx and MSP430x4xx microcontroller families to circuits with a supply of 5 V or higher is shown. Input, output and I/O interfaces are given and explained. Worse-case

Boost converters are susceptible to large inrush currents at startup and with step changes in VLINE because the output capacitor is connected directly to the input through the boost diode. This design note describes and provides a schematic for a circuit that provides overcurrent shutdown using the UC3853 High Power-Factor Preregulator. The UC3853 provides simple yet high-performance active power

This application report presents a hardware and software solution for interfacing the TLV2544/TLV2548 12-bit, 200-ksps, 4/8-channel, low-power, serial, successive approximation register (SAR) analog-to-digital converters (ADCs) to the 32-bit floating point TMS320C3X digital signal processor (DSP) through the use of the TMS320C31 DSP starter kit (DSK).

A digital-to-analog converter (DAC) interface to the DSP is also presented here exclusively for the single-shot mode operation of the ADC, since the DAC is used to reconstruct the digital data from the ADC for verification purposes. The TLV5618A DAC is used for this report.

ALM2402Q1 ALM2402Q1 Applications Note

This application report assists in estimating the power consumption for the TMS320C5515, C5504, C5505, C5514, C5532, C5533, C5534, and C5535 devices (DSPs), using a power estimation spreadsheet.

TMS320C6747/45/43 & OMAP-L1x7 Universal Serial Bus Downstream Host Compliance Testing

Forced air systems that direct temperature controlled air to a specific area are available but are large cumbersome and expensive. This application report describes a portable low cost temperature forcing system.

With the increasing use of current-feedback amplifiers the Diamond Structure has come to play a key role in today's analog circuit technology. Two new macro elements that function in this structure are the Diamond Transistor and its abridged version the Diamond Buffer. These elements can be used for both voltage and current control of analog signals up to several 100MHz. The OPA660 combines both

This application report presents a solution to control an AC induction motor using floating point TMS320F2833x microcontrollers. TMS320F2833x devices are part of the family of C2000™ microcontrollers which enable cost-effective design of intelligent controllers for three phase motors by reducing the system components and increase efficiency. With these devices it is possible to realize far m

This application report describes the way to interface the TMS320C54x™ digital signal processor (DSP) with an I2C device. The setup uses the multichannel buffered serial port (McBSP) configured as general-purpose input/output port and is coupled with a timer interrupt to implement the I2C protocol. An attempt has been made to provide a glueless interface to the DSP. However due to the curr

Application Note 1447 Improving PSRR and CMRR in Fully Differential Amplifiers

TPS54388-Q1 Pin Open and Short Test Results