This application note describes the performance and characteristics of the Compact Reach Xtend™ chip antenna. This antenna is specifically designed to operate at 2.4 GHz and combines small size with high performance to improve the functionality of RF devices.

Driving High-Speed Data Against the Traffic

bq27541-V200 Configuring the bq27541-V200 Data Flash

Upgrading to the new ADS85xx series of devices

This application report explains device behavior under slow battery-supply voltage ramp-up and ramp-downconditions based on device supply-rail configuration. Laboratory test results and device simulationsresults are included to support the analysis and device behavior.

CC3000EM-RD SimpleLink Wi-Fi CC3000 EVM Reference Design Test Data

HDQ Protocol Implementation with MSP430 Application Report

TPS6213x/4x/5x/6x/7x How to Measure the Control Loop of the TPS62130/40/50/60/70

This application note describes the design of a circuit using the Texas Instruments TPS2306 hot swap power manager to sequence the supply voltages limit inrush current and provide fault protection to a dual-supply voltage system. The system uses both 3.3-V and 5-V power and is modeled as a resistor in parallel with a bulk filter capacitor at each input power rail. Component values are selected

PGA309 Quick Start System Reference Guide

The Texas Instruments bq27505 series system-side Li-ion battery fuel gauge is a microcontroller peripheral that provides fuel gauging for single-cell Li-ion battery packs. The device requires little system microcontroller firmware development. The bq27505 resides on the system main board and manages an embedded battery (nonremovable) or a removable battery pack.

This application report presents a solution to control a half-bridge LLC resonant DC/DC converter with synchronous rectification system using TMS320F2802x microcontrollers. The Piccolo;trade; TMS320F2802x series of devices are part of the family of C2000;trade; microcontrollers that enable cost-effective design of power supply systems. With these devices it is possible to control power stages in

This document describes application examples and reference designs for the TPS61040 boost converter. The following application example describes how to implement the TPS61040 low-power dc-dc boost converter to drive white light LEDs. Also provided are design equations for calculating the proper resistor values for a white LED driver that includes provisions for dimming the LED brightness. The ref

What follows is information about the older test method and what it accomplished partial discharge how we test for it and a comparison of similar products tested using the different methods. Some of this material appears in the ISO120/121 PDS but bear repeating to give you the whole story.

Isolated Supply Overview and Design Trade-Offs

Operation Schemes of Touch Screen Controllers

TVP5146M2 ROM (08.00) ComparisonIn this document only those additional features that are pertinent to TVP5146M2 are described. For more information see the TVP5146M2 data sheet TI literature number SLES141.

DRV2605 IAR Setup for the DRV2605EVM-BT Firmware

This application note provides key recommendations for implementing serial communication systems that exceed IEC immunity test standards. To provide an example of highly reliable serial communications system implementation and testing a Texas Instruments DP83640 Ethernet Physical Layer device was tested for International Electrotechnical Commission (IEC) immunity test compliance. Results from the