CLARKE & PARK TRANSFORMS ON THE TMS320C2xx

The TMS320C6000? circular buffer block size must be specified as a power of 2. However some filters require coefficient/data table sizes which are not a power of 2. This application report shows an easy work around to implement the circular buffer with any block size.

This application note discusses the operation of system-oriented DC-DC conversion techniques.

This article has been contributed to the TI DaVinci™ and OMAP™ Developer Wiki. To see the most recently updated version or to contribute visit this topic at:

http://wiki.davincidsp.com/index.php/C6747/45/43_Complementary_Products .

This Wiki article serves as a repository of complimentary dev

Hardware Based UART Auto BAUD Correction

Inputs Currents for High-Resolution ADCs

This application reports provides 10 considerations for your use of an RS-485 interface.

This application note introduces the UC3879 integrated circuit and compares its performance to that of its predecessors the UC3875/6/7/8 controller family. These integrated circuits provide all necessary control decoding protection and drive functions to successfully manage the operation of the full-bridge converter with phase-shifted control. This integrated solution greatly simplifies the de

Isolation is a means of preventing DC and uncontrolled AC currents between two parts of a system, while allowing signal and power transfer between those two parts. Electronic devices and integrated circuits (ICs) used for isolation are called isolators. Isolation is required in modern electrical systems for a variety of reasons. Some examples include protecting human operators and preventing damage to expensive processors in highvoltage systems, breaking the ground loop in communication networks, and communicating to high-side devices in motor-drive or power-converter systems (Figure 1). Examples of applications that need isolation include industrial automation systems, motor drives, medical equipment, solar inverters, power supplies, and electric vehicles (EVs).

Recent advances in isolation technology are enabling new solutions, reducing system cost, and allowing customers to push the performance envelope of their equipment. This article discusses key end applications that are driving cutting-edge innovations in isolation technology and benefitting from these innovations.

The reference design and application examples shown in this document help design a TFT-LCD power supply as well as show implementations of power-down sequencing programmable sequencing and boosting output current.

Samples of the Texas Instruments (TI™) TMS320C6201B DSP will be available in the second half of 1998 with volume production starting at the end of the year. The TMS320C6201B revision is manufactured using a 0.18-micron process compared to the currently available revision 2 that uses a 0.25-micron process. The use of a smaller process for the TMS320C6201B DSP will lead to significantly lower

This application report is a general guide for using the CDC7005 clock synchronizer/synthesizer and jitter cleaner from Texas Instruments. This report explains the basic functionality and methods for using the device efficiently along with the results of evaluations. It also describes the clock termination method decoupling the power supply and general applications.

JPEG compression/decompression technique is widely used for still image applications. There are two major ways to implement JPEG algorithm--hardware and software. The hardware approach is good for spe

Application Note 446 A 150W IC Op Amp Simplifies Design of Power Circuits

Cost and performance requirements continue to push the packaging of electronic systems into smaller and smaller spaces. The advent of surface-mount devices has brought pin spacings that differ from on

As intermediate bus voltages decrease, a corresponding increase in line card load currents further complicates the design of power distribution and control sub-systems in networking equipment. As one

Frequency Dithering with the UCC28180 and TLV3201

DN116 -- Clearing Module Interrupt Flags in LPW SoC Devices

This document describes how to link together the GSM full-rate (FR) half-rate (HR) enhanced full-rate (EFR) and adaptive multi-rate (AMR) voice coding implementations on the TMS320C62x(tm) digital signal processor (DSP).

SN65DSI83 SN65DSI84 SN65DSI85 SN65DSI8x Video Configuration Guide and Configuration Tool Software Users Manual