Conventional regulators have a high drop-out voltage that is a function of the total output current.However with just a regulator chip an external transistor and a few passive components this designforms a high output current regulator with a limited input voltage and high efficiency. The circuit presentedhas a drop-out of 0.7V at 5A load current and 1.3V at a current level of as high as

TPS386000-Q1 Pin FMEA

WEBENCH? Allegro Connector

This application report presents the implementation details of a digitally controlled DC-DC converter that is used as a front-end converter for solar inverter (DC-AC) application. It implements an isolated DC-DC stage with maximum power point tracking (MPPT) algorithm in order to utilize the full capacity of a 500W solar panel. It maintains its input voltage at the reference set point generated by

This document describes an integrated acoustic signal processing system that provides adaptive noise cancellation acoustic echo cancellation and adaptive active noise control for hands-free cellular telephones. It discusses the software and hardware for the integrated acoustic signal processing systems the testing of the system and its results. This application uses the TMS320C3x family of 32-b

LB-2 Feedforward Compensation Speeds Op Amp

Conventional logic devices incorporating boundary-scan with the IEEE 1149.1 offer improvements in board testing. This document discusses traditional testing methods the SCOPE device testing methods and compares the two. This document is reprinted with the permission of the IEEE.

DRV8809/DRV8810 EVM

The TI SN74ACT36xx 36-bit clocked FIFO family interfaces to a 32-bit floating-point DSP allowing high-integrity data transfer and improving system throughput. This document describes the patented synchronous retransmit FIFO feature used with a DSP for FIR digital filtering. Two examples of DSP application specific FIFOs are given. The first uses the unidirectional SN74ACT3641 (1024 ? 36) FIFO a

TPS54372-Q1 Pin Open and Short Test Results

Although the TMS320C30 serial ports were designed to be used as synchronous ports they can be used as asynchronous ports under software control. This application note describes the hardware and software to use a TMS320C30 serial port as an asynchronous port. A schematic diagram and a lengthy code listing are provided to illustrate the solution.

PIN Diode Drivers

Going Beyond the Front End (Zero-Drift, Programmable Instrumentation Amplifier with D iagnostics)

The Texas Instruments RF430CL330H Dynamic NFC Interface Transponder is a NFC Forum Type 4B Tag Platform operating at 13.56 MHz (HF band). The device provides the flexibility to be used in combination with various antennas to meet the application performance requirements.

The scope of this document is to provide a short practical guide on the basic antenna design approach.

Crystal Oscillator and Crystal Selection for the CC26xx and CC13xx Family of Wireless MCU /Connectivity/App_Reports/2-CCxxxx_AppReports/CC26xx_CC13xx_SWRA495/SWRA495

bq769x0 Family Top 10 Design Considerations bq76920, bq76930, bq76940