This application note provides an overview of the M-LVDS standard, introduces Texas Instrument?s current M-LVDS product portfolio, describes common M-LVDS applications, and details important design gu

This Application Note describes how to configure the LM3524 as a transformer isolated flyback power supply.

This application report describes how to set up an open source software-based development environment for the SimpleLink CC26xx and CC13xx wireless MCUs using Eclipse as integrated development environment (IDE).

Certain applications require that output voltage regulation be maintained when the input voltage is only slightly higher than the output voltage. For a buck converter these low headroom operating conditions require high duty cycle operation that may approach 100%. As the converter on-time duration approaches the switching period the charge on the BOOT capacitor must be maintained in order for th

One advantage of parallel processors (PPs) is that their performance is made scaleable by the addition of more processors to the system. Interprocesor communication is guaranteed by high-speed interfa

A DSP/BIOS AIC23 Codec Device Driver for the TMS320C5510 DSK Application Report

This application report contains implementation instructions for the Serial Rapid I/O (SRIO) interface on the TMS320C6455 DSP device. The approach to specifying interface timing and physical requirements for the SRIO interface is quite different than previous approaches for other interfaces.

Serial Rapid I/O is an industry-standard high-speed switched-packet interconnect. Physical layer data t

The SN74ABT3613 and SN74ABT3614 FIFOs contain the parity-generate and parity-check features needed for high-bandwidth and high-speed computing applications where demanding data integrity levels are required. This document discusses these features of the 36-bit FIFOs that are designed for fault-tolerant systems such as those found in computing and telecommunication systems.

This application report provides an overview of the need for, implementations of, and characteristics of electrical isolation in high-speed digital circuits. It discusses the advantages and disadvanta

This application report describes the operation and performance of a 12-V to 2-V 20-A synchronous buck regulator evaluation design using the TPS5210 Programmable Synchronous Buck Regulator Controller. Experimental data shows tight static and dynamic regulation (?55 mV) fast transient response (within 1 micosecond) high efficiency (up to 90%) and stable operation with good noise immunity. The TP

Gives the recommended PCB layout for the PT3100/4100 series DC-DC converters and gives guidance on the expected thermal resistance and temperature rise Vs power dissi-pation.

This application report shows how to implement a single-chip thermocouple interface. The thermocouple interfaces with the MSP430F5529’s integrated 12-bit analog/digital converter (ADC12_A) through an operational amplifier circuit. The MSP430 encodes the thermocouple readings into a digital value converts them to temperature and stores them in memory.

Sitara Evaluation Module (EVM) PROFIBUS Test Data

TCAxxxx I2C Bus Pull-Up Resistor Calculation

Tracking dc/dc converters must track a reference voltage. However the rate of change in the reference voltage that the output voltage can successfully track is limited. This application report presents a typical application circuit and the reasons for these limitations along with the waveforms showing circuit performance when the reference voltage slew rates are increased above the maximum.

A Low-Noise Precision Op Amp

System designers require accurate component power consumption specifications for the purposes of thermal management component selection and power distribution planning.