This document describes how to run a program in RAM load another application to the RAM base address and map the whole RAM to address zero without using a software interrupt in the boot memory block. The mapping is necessary for example if the RAM application needs to use specific interrupts. The interrupt vector table for the RAM application has then to be mapped to address zero.

The C674x Floating-point Processor generation combines a new level of performance / precision and dynamic range with high power efficiency and system integration. The C674x processors are completely code compatible with other C67x processors.

Application Note 337 Reducing Noise on Microcomputer Buses

TPS659037 Design Checklist Excel (for sorting and filtering information)

AN-414 Precautions for Disk Data Separator (PLL) Designs - How to Avoid Typical Probl ems.

Hermetic Dimensional/Thermal Data

This design was created to help those wanting to design a TMS320C6472 digital signal processor into a system using a nominal input of 12 V, having a highly flexible power design, and the ability to mo

AN-1153 COP8 Flash ISP HANDBOOK – Virtual E2 Guide

This application report provides points to be considered when upgrading an existing 10/100 Mb/s Ethernetdesign using Intel’s LXT971 or LXT972A Ethernet Physical Layer (PHY) product to the new TexasInstruments DP83848C/I/YB PHYTER™ product.

Normally the UCC3809 programmable duty cycle clamp feature is limited to 70% maximum duty cycle. The described technique shows how the maximum duty cycle clamp can be programmed to achieve a 90% on-time of the switching period.

This document describes the functionality of the TMS320DM6467 Digital Media System-on-Chip (DMSoC) ARM ROM bootloader (RBL) software. The ARM ROM bootloader resides in the ROM of the device beginning at address 0x00008000. The RBL implements methods for booting in the listed modes and uses boot configuration pins to determine boot mode. If an improper boot mode is chosen or an error is detected d

There are two pairs of AIC registers, TA, TB and RA, RB, which control the sampling rate, fs, and low-pass filter cutoff frequency, fc. (The T and R mean transmit and receive.) This document discusses

TRF3705, TSW3725EVM TSW3725 Performance and Required Modifications Using the TRF3705 LEAVE IN MS WORD

This application report highlights new features and functionality in Code Composer Studio? v2.2. In addition to providing enhancements and bug fixes from Code Composer Studio v2.1, the latest version

A range of bridge-type transducers can measure numerous process variables. This report describes a pressure transducer and a bridge transducer to measure strain in mechanical elements. It gives an example circuit from which to implement other applications.

This report describes the implementation of I2C communication between the MSP430F16x USART or the MSP430F2xx USCI I2C hardware module and an external EEPROM (24xx128). The application report implements various EEPROM protocols such as Byte Write Page Write Current Address Read RandomAddress Read Sequential Read and Acknowledge Polling.

TVP5147M1 Patch Code Download Guidelines

This application report shows how to use the CC112x and CC12xx series of transceivers in a Frequency Hopping Spread Spectrum system. This allows for transmit powers up to 1 W and utilization of narrow