The input to each of the members of the ADS Family (ADS7804/05/06/07/08/09/10/19 so far) is a resistor divider network converting the input signal to the range used internally. This resistor divider offers inherent overvoltage protection which will often simplify analog circuitry.

This Application Note describes a method of interfacing a given microcontroller with a Texas Instruments digital temperature sensor.

The bq27x00 is a complete gas gauge solution for lithium-ion and lithium-polymer batteries. The bq27x00 also has internal registers and control commands that enable the host to use it as a battery monitor. A battery gas gauge solution can be built one of two ways: ignore all algorithms built into the bq27x00 and use the primitive functions to build a fully customized solution or use some of the h

AN-587 C in Embedded Systems and the Microcontroller World

This application note discusses driving LEDs using the LP3933 Back/Funlight Management IC system.

LB-19 Predicting OP Amp Slew Rate Limited Response

Application Note 1110 LVDS Quad Dynamic I CC vs Frequency

Using TI's CDCV304 with Backplane Transceiver (TLK1201, TLK1501, TLK2201, TLK2501, TLK2701, TLK3101)

The TI TC211 full frame charge coupled device (CCD) image sensor is used with the TCK-211 evaluation board to illustrate full frame CCD timing compatible with the EIA RS-170 standard. This document aids in the design of timing for the TI full frame CCD image sensors. The TC211 timing necessary to perform correlated double sampling (CDS) and antiblooming is included. This timing is only one method

The Texas Instruments DM646x devices support interfacing to a peripheral component interconnect (PCI) bus through its PCI port. The system or the application may contain a PCI Express® interface. In order to connect the PCI Express bus to the DM646x PCI bus an XIO2000A translation bridge is used. XIO2000A is a PCI Express to PCI/PCI-X™ bus translation bridge.

This application report provides technical background on nFBGA packages and explains how to use them to build advanced board layouts.

Understanding Portable Applications Requirements to Improve System Performance

Development can begin now for the Texas Instruments TMS320C6713 highest-performance peripheral-rich floating-point digital signal processor (DSP) systems. Because of the compatibility between TMS320C6000?DSP platform devices existing C6000?software tools and development platforms can be used to develop code for the C6713 and other future devices. This capability a

Spreeta Application Brief 005

In many applications a constant-current constant-voltage (CC/CV) dc source is needed. The I-Vcharacteristic of a constant-current constant-voltage (CC/CV) source is shown in Figure 1. This applicationreport presents an external op-amp based accurate current limit circuit suitable for CC/CV operation whenthe required constant current range is very narrow.

DN009 -- Upgrading from CC1100 to CC1101

In addition to the IALG interface that is required for an algorithm to conform to the TMS320? DSP Algorithm Standard an additional interface can be implemented to enable consumers to take advantage of the Real Time Analysis (RTA) capabilities of DSP/BIOS libraries. The Real-time Trace Control Interface (IRTC) defines an interface that when implemented allows a module?s various RTA modes to be

DRV8662, DRV2665, DRV2667 DRV8662, DRV2665, and DRV2667 Configuration Guide